NouvelleSkin Microcurrent & LED Facial Toning Device

What it is: The NouvelleSkin Device is an FDA-cleared, at-home facial tool that combines microcurrent and LED light therapy to lift, firm and rejuvenate your skin—safely and effectively.

What it does: Use the microccurent device to tone facial muscles in minutes or switch to red and infrared LED light to smooth lines and boost skin radiance. Customizable settings allow you to give yoru skin what it needs, when it needs it. The device features four different modes for targeted anti-aging benefits. "Stamp" mode helps visibly banish stubborn wrinkles, while "Lift" mode uses microcurrent to help fight sagging. "Eye" mode works to help boost collagen and fade stuborn eye wrinkles and "SL" mode boosts nose-wing collagen while helping visibly fade stubborn nasolabial folds.

How to use: Before using the device, we recommend performaning a quick skin sensativity test: clean a small area on the inside of your arm. Apply a small amount of gel to the area. Test by using the device on LIFT Mode (Level 1) for 3 minutes.

Wait and check for any reactions within 24 hours. If no irritation occurs, you can proceed with use.

- Step 1: Cleanse your face and apply gel.

Before using the device, remove any makeup, cleanse your face thoroughly, and take off any metal jewelry or contact lenses to prevent injury or device malfunction.

Use only with the official JMOON Gel. Apply the gel to the areas you plan to treat.

- STAMP Mode-Stimulate Collagen: Use 1-4 times per week. It can be used on all facial areas, excluding the eye sockets, lips and inside the mouth. Start at Area 1 and apply gel and hold the device for 6 seconds until you hear 2 short beeps and vibration, then move to the next stamping position. Spend about 2 minutes on each area (Area 1, Area 2, Area 3). After 6 minutes, the device will signal with a long vibration and 4 beeps to indicate the session completion.

- LIFT Mode-Lift and Sculpt: Use 3-4 times per week, 6 minutes per session. Start on the Area 1, apply gel, and use for 3 minutes. After 3 minutes, the device will signal with a short vibration and 2 beeps, indicating it’s time to switch areas. The mode light will flash, and the device will pause for gel reapplication. After finishing, the device will signal with a long vibration and 4 beeps to indicate completion.

- EYE Mode-Blur Fine Lines: use 3-4 times per week, 4 minutes per session. Can be used on the browbone, outer and under-eye areas. Start on the Area 1, apply gel and use for 2 minutes. After 2 minutes, the device will emit a short vibration and two beeps, signaling it's time to switch areas.

- SL Mode-Smooth Smile Lines: use 3-4 times per week, 4 minutes per session. Can be used on the right and left nasolabial folds Start on the Area 1, apply gel and use for 2 minutes. After 2 minutes, the device will emit a short vibration and two beeps, indicating it’s time to switch areas. Reapply gel, press the mode button, and continue. After 2 more minutes, the device will signal with a long vibration and 4 beeps to indicate completion. Reapply gel, press the mode button and continue. After 2 more minutes, the device will signal with a long vibration and 4 beeps to indicate completion.

Suggested Use:

- Combine LIFT with EYE or SL modes 3–4 times a week, 10 minutes each

- Use STAMP mode separately 1–4 times a week, 6 minutes each

- To protect your skin barrier, limit each session to no more than 15 minutes (excluding prep time)